UV Systems for Open Channels and Reservoirs

Channel and Reservoir Series

ULTRAAQUA’s SS C and PP C Series offer a very low head loss solution for open channel systems. The series is commonly used for municipal wastewater treatment facilities and aquaculture systems. The series is modular and can be expanded to treat any flow.

  • Modular frame and control system
  • Polypropylene or electro-polished stainless steel AISI 316l construction
  • Simple installation, operation and maintenance
  • Vertically installed LPHO amalgam lamps accessible during operation and no submerged electrical components
  • No tools needed for maintenance and frames can be handled and installed without lifting devices
  • Continuous lamp performance and lifetime monitoring
  • Optional level switch and UV sensor
  • Available with standard or advanced controls
  • Customized systems available


For water levels between 1.0 to 2.0 m


Systems are available in both stainless steel (SS) and polypropylene (PP)

WHAT TO CONSIDER

1. Third party validated UV-system

Our 350 VAL series is performance validated according to Önorm M 5871-1/DVGW Work sheet W294-

Please note that 220, 350 and 440 series are based on the same design principles and quality components. Key components such as UV-lamps, quartz sleeves, lamp drivers, sensors etc. are produced after the exact same very high technical standards.

2. UVT

UVT describes how well UV-light penetrates the water. In relation to UV-system sizing this parameter is as decisive as water flow rate. In general, the higher water quality, the higher UVT. However, water that looks very clear can have low UVT if it contains certain dissolved substances such as iron, manganese).

AWT-Asia will free of cost measure UVT or we can estimate it based on our vast experiences. For low UVT application, please consider ACN series.

 

3. InLine (440 series) or U-configuration (75, 220 and 350 series)

In many cases it is an advantage that inlet and outlet is at the same level. Especially, this often applies for installation into existing pipe systems. If the UV-system is installed with a by-pass, the U-configuration is simpler.

 

4. Custom made systems

ULTRAAQUA can produce optimized custom made UV-systems based on your specific requirements. As an example we can deliver UV-systems with customized connection sizes and/or orientation. We can also produce systems even bigger than the standard stocked systems. Please contact us directly.

 

 

 

 

 

×

 

PRODUCT SPECIFICATIONS

Please see our brochures for product details and specifications.